|
ST1300 DASH SHELF
INSTRUCTIONS
FOR ABS AND NON ABS
MODELS
1. PUT BIKE ON
CENTER STAND.
2. MOVE WINDSHIELD
TO FULL UP RIGHT POSITION.
3. REMOVE
WINDSHIELD
4. REMOVE BODY
WORK UNDER WINDSHIELD.
5. INSTALL THE
ENCLOSED SPEED NUTS AT EACH LOCATION OF THE BODY WORK WHERE THE PLASTIC
PUSH PINS ATTACHED THE BODY WORK UNDER THE WINDSHIELD.
6. INSTALL THE TWO
SPEED NUTS MARKED CENTER DASH IN THE TWO TOP CENTER FASTENER POSITION OF
THE INNER DASH.
7. REINSTALL THE
CENTER SECTION OF THE BODY WORK. USE THE ENCLOSED 6 X 20 MM PAN HEAD
SCREWS WITH A FLAT WASHER UNDER EACH SCREW.
8. SET THE TWO
SPACERS ON THE TOP TWO CENTER FASTENER POSITIONS.
9. SET DASH SHELF
ON TOP OF SPACERS INSERT THE TWO 6 X 30 MM PAN HEAD SCREWS.
10. ATTACH EACH
BRACE WITH YOU CHOICE OF THE 6-32 PAN HEAD FASTENERS AT EACH CORNER OF
THE DASH.
11. ATTACH THE
BOTTOM OF EACH BRACE TO THE TOP PHILLIPS HEAD SCREW OF THE INNER DASH.
12. FINISH
TIGHTENING ALL PAN HEAD FASTENER AND PHILLIPS HEAD SCREWS.
13. REINSTALL THE
WIND SHIELD.
|
