KRUZER KADDY, Handlebar Drink Carrier: K-KADDY With switch mount
MOUNTING INSTRUCTIONS
MOUNTING INSTRUCTIONS
STEP ONE: Choose the location on the handlebar where you
want your KRUZER KADDY located.
It is
best to locate the chrome handlebar clamp on a straight portion of your
handlebars, as the bending process used by the handlebar manufacturers
deforms the shape of the bars and may cause the clamp to not fit
properly.
Be sure
to choose a location that is high enough on the bars to insure clearance
between the bottom of the KRUZER KADDY and the
fuel tank.
The
mounting stud maybe placed either above or below the handlebar.
Using the
supplied allen wrench, attach the bracket onto the handle bar.
STEP TWO: Attach the cup to the bracket by placing the
grooved bracket tip into the keyhole located on the side of the cup.
Slide the cup down onto the bracket.
STEP THREE: Insert the rubber grommet into the lower
portion for the cup keyhole. This will secure the cup to the mounting
stud.
When using
the KRUZER KADDY on 7/8th diameter bars, a
split-plastic busing is supplied with each KRUZER KADDY.
Spread the bushing apart and slip it over the 7/8th bar. Then place the
handlebar clamp over the plastic bushing and squeeze the two clamp
halves together. The clamp screws may now be tightened and the cup can
be attached as per STEP TWO and
STEP THREE above.
KRUZER LLC recommends the use of the rubber grommet to
secure the cup to the mounting stud. This will insure that the cup does
not dislodge should you hit a rough pothole or other road obstacle. This
is especially true for ATV or off-road riding.
Each
KRUZER KADDY comes with 2 removable insulated liners. The
thick liner is for 12oz cans or 16oz water bottles and the thin neoprene
liner is for 20oz soda or water bottles. One liner must be removed for
the other to be used.
KRUZER KADDY, Handlebar Drink Carrier: K-KADDY With switch mount $53.00$42.95 Our Price
