Flash2Pass™ Installation
The Flash2Pass™ transmitter and receiver are designed as a do-it-yourself
installation. It is very simple and straight forward if you follow the
instructions included in every set. If you purchase a separate Flash2Pass™
transmitter or receiver, instructions are not only included for installation but
also for programming the transmitter/s to the receiver/s.
Transmitter installation on a motorcycle
Installation of the Flash2Pass™ transmitter on a motorcycle is very
simple. Depending on the model of motorcycle, the easiest way to do it is to
remove the headlight from the bucket as if you were changing the bulb, and
connect the transmitter, as described above in the car installation. Then just
tuck the transmitter into the bucket and reinstall the headlight. Again, this
may not be applicable to every installation, but it is a general rule of thumb.
Click on Motorcycle Installation Guide
above, or to the left, for more information.
Receiver
The Flash2Pass™ receiver is even easier to install. There are two wires
that go from the garage door opener motor to a pushbutton on the wall that you
use to open the garage door from the inside. After disconnecting the power to
the garage door opener, you will remove the pushbutton from the wall, undo the
two wires from the back and attach them to the Flash2Pass™ receiver, and attach
the receiver to the wall. Turn the power back on, and that's it!
If your current pushbutton console has functions other than to open the door,
like light and lock switches, you can still keep those functions by using
"jumper" wires from your current console to the Flash2Pass™ receiver. Complete
instructions are included with every set and separate receiver.
Click here to find the Complete Installation
Instructions in PDF format
You will need Adobe Acrobat Reader™ to view the Complete Installation
Instructions. If you don't have Adobe Acrobat Reader™ you can download it
for free by clicking on Acrobat Reader™ icon below.
