StarCom1 Advance Installation Idea's

New Page 3

2006 Brochure
StarCom1 and the new StarCom1 Advance

StarCom1 Advance
Instruction & Installation manual

StarCom1 Digital
Instruction & Installation manual

Installation Idea's

StarCom1 Advance is a great addition to any bike. It adds music; Driver to passenger communication; It can interface FRMS and CB radios; Radar detectors and navigational voice commands from your navigation unit (Optional)

StarCom1 Advance can easily be installed on any bike. It takes about the same amount of room as a normal deck of playing cards. Just add a switched 12 Volt DC source and plug in the connectors. It is that simple.

StarCom1 Advance can also be installed in a tank bag using Powerlet. These connectors give you the ability to easily add connectors in and on your tank bag.

IPod

The IPod can easily be installed on the Handle bars using Ram Mounts giving easy access to changing channels and music volume.

The IPod compatible cable is included with every StarCom1 kit.

RAM MOUNT KIT HANDLEBAR MOUNT FOR IPOD NANO RAM-B-149Z-AP2U

The RAM Cradle is designed to hold the following Apple iPod units:

Apple iPod Nano 1GB (1st Generation)
Apple iPod Nano 2GB (1st & 2nd Generation)
Apple iPod Nano 4GB (1st & 2nd Generation)
Apple iPod Nano 8GB (2nd Generation)

Zumo Idea's

The Garmin Zumo is a great addition. It can add Bluetooth to StarCom1 Advance without the need of a StarCom1 Bluetooth module.

With the Garmin Zumo 550, you can add XM radio (optional XM subscriptions and an XM antenna would be needed.) To add Garmin Zumo to the StarCom1 Advance, you will need a Starcom1 Navigation/Radar Interface Cable (CAB-55) or a Starcom1 Microphone Cable for Garmin Zumo™ (MIC-01) and a StarCom1 Music System Interface Cable (MUS-04) The difference is the CAB-55 will only allow mono music.

The MUS-04 will also work with most all Garmin GPS units that have a 3.5mm audio output.

We do recommend a SanDisk 2 GB SD Memory Card. With the 2GB disk you are able to add MP3 music and listen though your Garmin Zumo.

Bike To Bike Communication

Bike to bike communication can easily be done with the use of any Midland Radio that we sell here.

All you need is a StarCom1 Push-To-Talk Handle Bar Switch, (PTT-02), for the driver and a Starcom1 Two-way Radio Interface Cable,(CAB-02), for the Midland Radio. You will, however, have to decide if you will be using a CB band radio or a FRMS radio. This usually depends on who you mostly ride with.